Application Procedure
General-The substrate must be clean, dry, structurally sound and free of efflorescence, oil, grease, form release agents and curing compounds. Painted surfaces are not acceptable and the paint must be removed.
Job Conditions - Air and substrate temperature for application of the Rollershield Mesh must be 40°F (5°C) or higher and must remain 40°F (5°C) or higher for a minimum of 24 hours.
Temporary Protection - Must be provided at all times until the wall system, including flashings, caps, and sealants, is completed to provide protection from climatic conditions and other potential damage.
Installation - Apply Rollershield Mesh according to Master Wall Specifications. In general, Rollershield Mesh is centered on the approved sheathing joints, corners, substrate transitions, etc. prior to the application of Rollershield weather barrier. Apply Rollershield Mesh and immediately paint or trowel Rollershield to hold it in place. See Rollershield Data Sheet for specific instructions. Lap Rollershield Mesh a minimum of 2-1/2 (63.5 mm).
Limitations
Rollershield Mesh is not intended for use as the exterior or primary reinforcement of any Master Wall Systems or for use with any other water barriers or base coats except Rollershield.
